Badcaps Forums

Badcaps Forums (https://www.badcaps.net/forum/index.php)
-   General Electronics Technical Discussion (https://www.badcaps.net/forum/forumdisplay.php?f=29)
-   -   Scr / thyristers (https://www.badcaps.net/forum/showthread.php?t=66831)

johnfin 01-07-2018 10:01 AM

Scr / thyristers
 
If the schematic calls for a 200v scr can i replace it with a 400v scr?

R_J 01-07-2018 10:16 AM

Re: Scr / thyristers
 
Yes, as long as the other parameters ar also as good or better ie: current

Longbow 01-12-2018 06:31 PM

Re: Scr / thyristers
 
That particular spec means that the device has to withstand at least 200v. reverse. But there are other important specs with thyristors, especially the turn-on voltage and turn-on pulse width required. Also, you need to look at requirements for the reverse voltage width. If too narrow, the SCR won't turn off. Or, you could just slap in the replacement and look for smoke (just kidding).

sam_sam_sam 01-20-2018 03:26 PM

Re: Scr / thyristers
 
What are you going to use it for resistance load or on a inductive load ?


All times are GMT -6. The time now is 05:04 PM.

Powered by vBulletin ®
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.