Try our new boardview, bios, & schematic search. Over 1.3 million files for download!

Real Panasonic FJ 1000uF 6.3V Capacitor?

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • mockingbird
    replied
    Re: Real Panasonic FJ 1000uF 6.3V Capacitor?

    Originally posted by c_hegge
    I have about 50 820uF 6.3v Panny FJ series which I have pulled off fairly new ASUS motherboards. They look identical to these. The printing on the sleeves looks the same, the rubber seal is the same. I believe that these caps are genuine.
    It's funny you mentioned this...

    I had to RMA an Asus P5GC-MX not too long ago. It had all Panasonic caps but it had stability issues as well as power issues and I wondered if Asus had gipped me with fake Pannys. They did look genuine though, not like the ones that were posted here.

    I can't test the replacement they sent me, because I have no LGA775 CPUs, but the one thing I did notice on this perhaps later revision specimen of the same model was that the itty bitty caps on it were now also pannys as opposed to OSTs or Teapos (Can't remember which) on the one I RMA'd.

    Leave a comment:


  • c_hegge
    replied
    Re: Real Panasonic FJ 1000uF 6.3V Capacitor?

    I have about 50 820uF 6.3v Panny FJ series which I have pulled off fairly new ASUS motherboards. They look identical to these. The printing on the sleeves looks the same, the rubber seal is the same. I believe that these caps are genuine.

    Leave a comment:


  • PCBONEZ
    replied
    Re: Real Panasonic FJ 1000uF 6.3V Capacitor?

    They look like the real deal to me.

    Leave a comment:


  • mockingbird
    replied
    Re: Real Panasonic FJ 1000uF 6.3V Capacitor?

    They look like fakes to me. The printing on the sleeves is poor, and notice how the internal part of the leads are protruding a little bit from the bunge (Like what happens when you pull on a lead too hard).

    Leave a comment:


  • yanz
    replied
    Re: Real Panasonic FJ 1000uF 6.3V Capacitor?

    it looks like nothing is wrong. here i have lots of 1500/6.2 FJ that has the same appeareance like yours. i use them a lot, so far so good. of course i choose my source carefully..

    Leave a comment:


  • yyonline
    replied
    Re: Real Panasonic FJ 1000uF 6.3V Capacitor?

    It's hard to say for sure without knowing the source, but I don't see anything that suggests these are fakes. They have the "T" vent, rubber plug matches what I've seen for 8mm diameter Panasonic. Font matches what I've seen on other FJs on motherboards.

    Leave a comment:


  • ant3202
    started a topic Real Panasonic FJ 1000uF 6.3V Capacitor?

    Real Panasonic FJ 1000uF 6.3V Capacitor?

    Hi peeeps and gurus...

    Recently I had brought a small quantity of Panasonic FJ Capacitors.
    I need your guys valuable experiences to distinguish if it is a genuine made capacitor. Many Thanks In Advance!!!



    Attached Files

    Premium supporters get full download access and other benefits.

Related Topics

Collapse

  • joetristan
    Tantalum capacitor burning out
    by joetristan
    Hello,
    I’m using a 10 µF, 20 V tantalum capacitor as a decoupling capacitor across a 5 V supply. When I power the circuit, the capacitor burns out.

    At first, I assumed the tantalum capacitor was defective and replaced it, but the new one burned out as well when the circuit was powered.

    I then replaced the tantalum capacitor with a 10 µF, 63 V electrolytic capacitor. This time, the capacitor did not fail after powering the circuit.

    I do not understand why the tantalum capacitor burns up?
    02-11-2026, 03:43 AM
  • Prolog
    RTX 3080 FE Identifying capacitor
    by Prolog
    Hi people, I hope this is the correct spot to post this, I'm new to the forum.

    I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.

    I hope these photos make it clear which component I am referring to:
    (yes, the soldering is a bit botched from removing the blown one, I know)

    I have found the board schematic (attached), but there does not seem to be a boardview available. I have never...
    12-01-2024, 08:27 PM
  • anty
    Lenovo Yoga 13 mb: Yoga 13 MB Panasonic capacitor identification
    by anty
    Panasonic capacitor identification...
    07-07-2023, 01:06 AM
  • woodboy971
    Need help – Identifying missing capacitor (HP CM 6050A2892401 MB A01)
    by woodboy971
    Hello everyone,
    I am a beginner in electronic board repair and I am looking for help with an HP motherboard: CM 6050A2892401 MB A01.

    Initially, the laptop would not power on. After troubleshooting and taking measurements, I found that a capacitor was shorted, which was preventing the system from starting. I removed this capacitor.

    After removing it, the PC now powers on for a few seconds and then shuts down. I believe this behavior is related to the missing capacitor, which is no longer performing its role in the circuit.

    My issue is that I cannot identify...
    12-27-2025, 10:31 PM
  • Quadro1000
    MXM Graphic card Nvidia Quadro K1000m /K2000M schematic or value of capacitor C55 capacitance and voltage from laptop HP8570w
    by Quadro1000
    Hi,

    I had a MXM graphic card type Nvidia K1000m from laptop HP8570w which had a broken capacitor.

    The ceramic capacitor seems was broken and makes a short circiut. The laptop goes off because of the short-circuit. But it seems currently that only the capacitor C55 was broken on the graphcic card.
    Because after I have desoldered it, the laptop runs with the card. But currently without this capacitor.
    So to have full functionality and no instabilities I want to replace it with a new one.

    So I need to know the value and voltage of C55 to replace...
    12-16-2025, 11:17 AM
  • Loading...
  • No more items.
Working...