100% cpu with no processes using it

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • 370forlife
    Large Marge
    • Aug 2008
    • 3112
    • United States
    #21
    Re: 100% cpu with no processes using it

    Right, but when it is your cpu usage should be at 0-1%. This was running at about 50% cpu usage (this cpu has HT so it was only using one thread.)

      Comment

      Previous 1 2 template Next

      Related Topics

      Collapse
      • kuba2102
        Medion Erazer beast x25 freezes and resets only at low CPU usage
        by kuba2102
        Medion Erazer beast x25 62307 MSN 30031969 GM5ZGXW AMD version

        Hello. The laptop freezes and resets only at low CPU usage, practically at IDLE after a few minutes. There is no problem under a load, and I benchmarked it for over an hour. I noticed that one of the CPU coils was making whining noise at low CPU usage. I previously thought it was a BIOS problem, but updated BIOS and no change. I'm thinking of changing the CPU DrMos'es there are 5 of them all together. I have already swapped the DrMOSes first one with the last one (I desoldered them and soldered in swapping DrMos no.1 with...
        01-06-2025, 09:14 PM
      • ADATA_C008/16GB
        10-character number and 4-characters string on USB Standard-A, "male" plug? Meaning and usage?
        by ADATA_C008/16GB
        I bought "ADATA C008 / 16GB" USB Flash Drive yesterday, and I'm curious about meaning and usage of this 10-characters number and 4-charatcer string on USB Standard-A, "male" plug.
        11-10-2024, 11:47 AM
      • CapLeaker
        TCL 65S450F no logo, bleeping sounds?
        by CapLeaker
        Got a brand spankin' new TCL 65S450F here. Plugged the TV in and it booted up and wanted a firmware update right away. O.k. I guess it did that or not... I got no forking clue. Came back in 10 mins later and the screen is black, backlights on. The Standby light is blinking and every 10 to 15 seconds makes bleeping noises. That's all she does. Tried a factory reset and that must work as I can adjust the volume of the bleeping and it returns to factory volume afterwards. Also tried big black button with the circle right button on the remote and no go.

        EDIT: No bootloop the bleeping...
        08-08-2024, 01:37 PM
      • howardc64
        Samsung UN65NU6950 edge lit TV LED bar after 10k usage hours
        by howardc64
        Edge lit LED TV has 1/4 section backlight out. Replaced the LED bars and sharing the findings on the original 10k hour LED bar.

        These are 6V LEDS (reads ~5.4+ on my LED tester) New bars read about 147V per 1/2 of each bar. Clearly original LED bar has some problems
        • One section is 153v with a dead LED so clearly built up resistance
        • One section flickers but magically fixed itself after driving individual LEDs. All done with an LED tester so don't know if would work driven by PSU backlight circuit and how long it would last
        • Connector pin to test pad resistance is nearly 0 ohms.
        ...
        07-07-2025, 12:18 PM
      • proxneo
        Bose Wave I AWRCC1 - intermittent to no sound output - loud popping & crackle sounds
        by proxneo
        Dear reader

        I have been asked to check out a faulty Bose Wave system belonging to a relative. The faulty unit produces loud intermittent pops and crackles. Sometimes there is speaker audio output (FM/AM, CD etc.), most of the time there isn't. This behaviour degraded over time fairly quickly, to the current situation where no sound is put out at all. Gently messing and wiggling wires, connectors or heatsink has no effect in force-replicating the problem. I have little experience in audio repair when it comes to (main)board electronic component faults. Bose repair WAS about 140$ (most...
        12-02-2023, 09:27 AM
      • Loading...
      • No more items.
      Working...