hp g6 failure

[dycc]

HP G6 failure series

--------------------------------------------------------------------------------

allready solved plenty board of this type with the same issue .

just a small resistor which lose connectivity at it power line
__________________

[whaldsz]

Re: hp g6 failure

where is this resistor? label?

[dycc]

Re: hp g6 failure

only for ROCKY2 Huron River Platform MV Build

check R1053(1Mohm) connectivity with V15A

[whaldsz]

Re: hp g6 failure

Ah ok, without it there will be no +V3S, +V5S, +V1.5S. Thank you for sharing.

[Francisco.s]

Re: hp g6 failure

only for ROCKY2 Huron River Platform MV Build

check R1053(1Mohm) connectivity with V15A

Could you please share this schematic?

[dycc]

Re: hp g6 failure

Here
https://www.badcaps.net/forum/showth...ighlight=hp+g6

[Francisco.s]

Re: hp g6 failure

Thanks.

[robrock1]

Re: hp g6 failure

my board is a different type from yours its nearly the same but components are different numbers but i still resoldered all the resistors but not working. i have 3.3v 5v and 5 v but still dead i think is from the chipset.

[dycc]

Re: hp g6 failure

What is your board code

[whaldsz]

Re: hp g6 failure

my board is a different type from yours its nearly the same but components are different numbers but i still resoldered all the resistors but not working. i have 3.3v 5v and 5 v but still dead i think is from the chipset.

Voltage of SIO chip at pin 112, pin21, and pin23 before and after power switch on? They should be high after power switch is on.

Also check INTRUDER#, RTCRST# and SRTCRST# pins if high.

[surajndsbadcaps]

Re: hp g6 hwpg power failure

HP g6 system power (3.3v and 5.0v) is perfect but still set does not power up. When I pressed the power button then i got the 3.3v in PL23 and 5.0v in PL20 still this board does not power up. There is no hwpg in pin no 14 of the ene kb3930qf a1. So, i replaced the OK tested power ic (tps 51123, pu3) and ok tested ene kb3930 too. but still same case as above. So, anybody post about solution................

I need hwpg (hardware power good) voltage help...........

[kandyan]

Re: hp g6 failure

I hv same problem in G62 board. all other voltages are ok but HWPG. nothing came out from HWPG. Anyone got a clue about this problem?

[dj_ricoh]

Re: hp g6 hwpg power failure

HP g6 system power (3.3v and 5.0v) is perfect but still set does not power up. When I pressed the power button then i got the 3.3v in PL23 and 5.0v in PL20 still this board does not power up. There is no hwpg in pin no 14 of the ene kb3930qf a1. So, i replaced the OK tested power ic (tps 51123, pu3) and ok tested ene kb3930 too. but still same case as above. So, anybody post about solution................

I need hwpg (hardware power good) voltage help...........

you need to reprogram BIOS
Caps key blink?

[mazloum]

Re: hp g6 failure

HP G6 failure series

--------------------------------------------------------------------------------

allready solved plenty board of this type with the same issue .

just a small resistor which lose connectivity at it power line
__________________

hi
can you help me please to fix it?
thanks