the board is already shows charging the led is in orange mode but has no power...
Hi mate,
If the Motherboard charging LED is orange (Please check current pull up - it should be more than 1 amps) then charging circuit is good. The next thing you need to check Coil PL46 and PL47 for 3.3 and 5 Volts respectively - If yes go to U16 (EC / SIO chip) Check pin 117 :PBTN OUT# it should read 3.3 Volts. If yes press the power button and check Pin 13 (PLT RST) it should give 3.3 volts output for turn ON. If no voltage from pin 13 check SPI bios (re-flash) first and then replaced SIO chip.
Check voltage 3.3 Volts on the power button - If yes : press the power button and see the voltage drops to 0 volts - If yes the power button circuit is OK. Check the bios and EC.
i already short the pin 7 and 8 of jled1 still no power..can i ask which pin should im going to meausre the voltage of power in the jled1,because only pin 1 and 2 shows 3v..
I am also having the same problem I'm getting voltage on pin 7 so know power going to the motherboard but the laptop is still dead don't know what to check next
Hi I am having a problem on this same board. 19V input connector shows 19V ok. Led 3 is blinking. On PL42 it show power fluctuation. its going down from 19V to 16V, 13V, 10V, 9V. I found a cap PC1011 is short circuited and i replaced it. but the problem still. I replaced PU17, PU1000 also but problem not solved. anyone having any idea ?
Hello1 I HAVE A PROBLEM WITH ACER ASPIRE 5742 ZG. POWER UP JUST FOR BATERY, PLUG IN AC POWER ADAPTER, NOT POWER UP. POWE BUTTON VOLTAGE IS 20V. ANYOANE CAN HELP ME?
Comment