I did a whoops while working on some tvs this weekend.
I had a working MLT668TL-V rev 1.1 supply testing a couple of tvs, and while testing I sat the board down on the back of a panel before the main cap discharged, resulting in a large pop. (The board wasn't plugged into anything at this point.)
Now the standby power is cycling every second or so.
Any clues on where to start?
Thanks.
Later,
dabone
I had a working MLT668TL-V rev 1.1 supply testing a couple of tvs, and while testing I sat the board down on the back of a panel before the main cap discharged, resulting in a large pop. (The board wasn't plugged into anything at this point.)
Now the standby power is cycling every second or so.
Any clues on where to start?
Thanks.
Later,
dabone
Comment