Got this monitor today.
At first it was just coming on with a white screen. I took it apart and it looked like only half of the LVDS cable was actually plugged into the T-Con board so I cleaned it then re attached it. Put it all back together and it worked.
I tried it again later on and it went back to randomly giving a white screen and sometimes the screen came on but it would have noise on the screen which would go away if you turned the monitor on and off again.
I have tested the voltage regulators on the logic board and on the T-con board and they seem fine and they are the same when the monitor is at fault and when its working.
Anyone have any ideas?
P.s I will get the pictures of the boards up tomorrow.
At first it was just coming on with a white screen. I took it apart and it looked like only half of the LVDS cable was actually plugged into the T-Con board so I cleaned it then re attached it. Put it all back together and it worked.
I tried it again later on and it went back to randomly giving a white screen and sometimes the screen came on but it would have noise on the screen which would go away if you turned the monitor on and off again.
I have tested the voltage regulators on the logic board and on the T-con board and they seem fine and they are the same when the monitor is at fault and when its working.
Anyone have any ideas?
P.s I will get the pictures of the boards up tomorrow.
Comment