Any suggestions.....
I have converted a Turbo Link ATX Switching Power Supply with 20 pin connector, Model No: WIN-350PS with AC INPUT 115/230V & DC OUTPUT: 350W to a lab power supply. I joined wires black gnd red +5v white -5v yellow +12v blue -12v orange +3v. Installed green wire to switch to gnd. Placed 10w 10o on red & black wires to use up power as per online instructions. I also wired in LED grey to black with resister.
When I start it up we get 1-2 fan and LED lit then everything goes into safe mode until I switch it off for a few minutes. The only time I can get it to run continuous is buy hooking up an old floppy drive first.
Absolutely stumped on how to fix this properly. Have tried different wiring arrangements and nothing seems to work.
Any ideas or help would be much appreciated.
Jeff
I have converted a Turbo Link ATX Switching Power Supply with 20 pin connector, Model No: WIN-350PS with AC INPUT 115/230V & DC OUTPUT: 350W to a lab power supply. I joined wires black gnd red +5v white -5v yellow +12v blue -12v orange +3v. Installed green wire to switch to gnd. Placed 10w 10o on red & black wires to use up power as per online instructions. I also wired in LED grey to black with resister.
When I start it up we get 1-2 fan and LED lit then everything goes into safe mode until I switch it off for a few minutes. The only time I can get it to run continuous is buy hooking up an old floppy drive first.
Absolutely stumped on how to fix this properly. Have tried different wiring arrangements and nothing seems to work.
Any ideas or help would be much appreciated.
Jeff
Comment