Need to replace CapXon C426 16V 1000uF 20mm x 10mm 105 degree in LG Flatron L1710S

[Lew]

Hello,

I'm not an expert at this but have had success with 2 motherboards and a monitor so decided to give it a shot.

I can't find a cross-reference for the CapXon C426. Have narrowed it down to the Panasonic EEU-EB1C102. Is it a good match?

I don't know how to go about getting the correct ripple current. The Panasonic is 430mA. The Capxon says KF in front of the 105 degree label. Is this a clue to the series or ripple?

Thanks!

Lew

[budm]

Re: Need to replace CapXon C426 16V 1000uF 20mm x 10mm 105 degree in LG Flatron L1710

EB is the general purpose, you should use FM, FR, or FC series low ESR/Impedance type, that are what I use for all my repair works.
Juts get the correct dimensions that will fit your board.

[Lew]

Re: Need to replace CapXon C426 16V 1000uF 20mm x 10mm 105 degree in LG Flatron L1710

Thanks Bud!

Digikey doesn't populate the ESR column for the selected Panasonic FM, FR, or FC series you specified, so is AEC-Q200 (non-general) application type with 52 mOhm impedance good?

Of the FM, FR, and FC series, the only Panasonic with my size and these characteristics is their EEU-FC1C102S.

[budm]

Re: Need to replace CapXon C426 16V 1000uF 20mm x 10mm 105 degree in LG Flatron L1710

It is better to download the datasheet for the cap series you are looking at.
https://www.badcaps.net/forum/showpo...2&postcount=65

[selldoor]

Re: Need to replace CapXon C426 16V 1000uF 20mm x 10mm 105 degree in LG Flatron L1710

Of the FM, FR, and FC series, the only Panasonic with my size and these characteristics is their EEU-FC1C102S.

Well that sounds good to me then.