Hi everyone I need help on this netbook msi u135dx the problem is battery stuck on 30% and it shows charging but only 30% and also cannot turn on on battery but works fine with charger. anyone please help
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
msi netbook u135dx battery not charging
Collapse
X
-
Re: msi netbook u135dx battery not charging
There is a mosfet after the dc in mosfet is AO4932 here is the reading charger only pin 1=19v pin 2=19v pin3=ov pin4=ov pin 5 to 8=0v but battery only inserted all pins have ov but battery and charger inserted pin1 and 2 =19v pin3 and 4 0v pin 5 to 8=12v. Also baterry and charger inserted only pin 3 have resistance.any advise please help
Comment
-
Re: msi netbook u135dx battery not charging
Do you have the schematic?
I think this is MSI wind U100
Try open the black tape near DC jack, there should be FET Q40 AO4413
Measure it in diode mode or ohm mode ( Don't apply power when you measure it in diode mode or ohm mode)
Link HD image:https://drive.google.com/folderview?...2s&usp=sharingLast edited by meritosari; 04-25-2017, 09:38 PM.
Comment
-
Re: msi netbook u135dx battery not charging
thanks for the response guys i measured again the mosfet AO4413 multimeter set to 200ohms
pin1 S1 black probe to pin 4 G1 red probe = 199.5 ohms
pin1 S1 black probe to pin5 D1 red probe = reading flashing
pin 4 G1 black probe to pin 5 D1 red probe = 193.6 ohms
pin 2 S2 black probe to pin 4 G1 red probe = 197 ohms
pin 2 S2 black probe to pin 5 D1 red probe = reading flashing
pin 4 G1 black probe to pin 6 D2 red probe = 190.3 ohms
pin 3 S3 black probe to pin 4 G1 red probe = 196.6 ohms
pin 3 S3 black probe to pin 5 D1 red probe = reading flashing
pin 4 G1 black probe to pin 7 D3 red probe = 188.6 ohms
pin 4 G1 black probe to pin 8 D4 red probe = 193.5 ohms
in seems that there is short on drain to source for the mosfet
and also notice 1 ceramip caps at back on dc have no resistance because ohms I Have attached the image. please anyone help on this please
Comment
Comment