Does this Bridge Rectifier bottom look bad? It's from a Elite Miracle-One gate opener.
I pull this board from my gate opener this morning after it blew a 3 amp fuse yesterday. The gates refuse to open when I hit the remote.
I checked the board and saw a fuse bad, I replaced the fuse and when I hit the remote button and the fuse blew again. I pulled the board and everything is normal on the top side but on the bottom I found two places the the solder looks rusty.
The first photo group is below the bridge rectifier, the second photos is from the under side near the left side of the board.
Does the rust color say something?
I pull this board from my gate opener this morning after it blew a 3 amp fuse yesterday. The gates refuse to open when I hit the remote.
I checked the board and saw a fuse bad, I replaced the fuse and when I hit the remote button and the fuse blew again. I pulled the board and everything is normal on the top side but on the bottom I found two places the the solder looks rusty.
The first photo group is below the bridge rectifier, the second photos is from the under side near the left side of the board.
Does the rust color say something?
Comment