Hello. I have Denon avr-1911. I like this amplifier, and hope to repair.
Before 2 days led lamp on stand by begin to blink red. I open receiver and:
1. FR chanell was blow. The power transistors 2SD2390/2SB1560 was shorted.
---I replace them with another darlington MN2488/MP1620. I think they are 100% equivalent with 2SD2390/2SB1560. If i wrong, please tell me.
2. 4 resistors 0.47oms, also was open. I replace with 0.33oms (hope this is not problem).
3. 2 resistors 22 oms, also was open. I replace it with same.
4. I the last one three small transistors was short (KTA1268/KTC3206). I replace it with 2SC2240/2SA970. I think they are good equivalent.
5. All zener diodes, all resistors, all trimers, all regulators are fine
I try to reset the proccessor, but no result.
I upload service manual. The bad channel is on 67 page.
I hope for any suggestion :/.
Before 2 days led lamp on stand by begin to blink red. I open receiver and:
1. FR chanell was blow. The power transistors 2SD2390/2SB1560 was shorted.
---I replace them with another darlington MN2488/MP1620. I think they are 100% equivalent with 2SD2390/2SB1560. If i wrong, please tell me.
2. 4 resistors 0.47oms, also was open. I replace with 0.33oms (hope this is not problem).
3. 2 resistors 22 oms, also was open. I replace it with same.
4. I the last one three small transistors was short (KTA1268/KTC3206). I replace it with 2SC2240/2SA970. I think they are good equivalent.
5. All zener diodes, all resistors, all trimers, all regulators are fine
I try to reset the proccessor, but no result.
I upload service manual. The bad channel is on 67 page.
I hope for any suggestion :/.
Comment