Hi i have an inverter board that i want to hack to only use 2 of the outputs.
I know i can use a resistor at each end to fool one output but thought i would pick some brains to see if i could isolate one end and use the other .
Not something i have tried before, repaired loads and replaced parts etc but this would be a new learning curve .
And yes i know i could buy a 2 lamp unit but where would be the fun in that
I have attached pics and a sheet for the controller ic .
In case you were wondering why? the new screen only has 2 lamps and not 4
I know i can use a resistor at each end to fool one output but thought i would pick some brains to see if i could isolate one end and use the other .
Not something i have tried before, repaired loads and replaced parts etc but this would be a new learning curve .
And yes i know i could buy a 2 lamp unit but where would be the fun in that
I have attached pics and a sheet for the controller ic .
In case you were wondering why? the new screen only has 2 lamps and not 4
Comment