Announcement

Collapse
No announcement yet.

Panasonic NHG caps suitable for starter cap?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Panasonic NHG caps suitable for starter cap?

    Jamicon 4.7uf 400v - exploded

    Have got a couple Panasonic NHG caps in same value, would they be suitable replacements? Starter cap, one at the bottom. Connector next to it is AC in.
    Attached Files
    Tags: None
    #2
    Re: Panasonic NHG caps suitable for starter cap?

    I do not see any reason why you can not use them

    It might be better if you used 450 volt caps instead 400 volt
    If the diameter is the right size and if it is not to tall
    Last edited by sam_sam_sam; 06-24-2017, 08:15 PM.
    9 PC LCD Monitor
    6 LCD Flat Screen TV
    30 Desk Top Switching Power Supply
    10 Battery Charger Switching Power Supply for Power Tool
    6 18v Lithium Battery Power Boards for Tool Battery Packs
    1 XBox 360 Switching Power Supply and M Board
    25 Servo Drives 220/460 3 Phase
    6 De-soldering Station Switching Power Supply 1 Power Supply
    1 Dell Mother Board
    15 Computer Power Supply
    1 HP Printer Supply & Control Board * lighting finished it *


    These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%

    1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
    2 Hem Saw Computer Stack Board

    All of these had CAPs POOF
    All of the mosfet that are taken out by bad caps

    Comment

      #3
      Re: Panasonic NHG caps suitable for starter cap?

      Man these caps must be terrible, two of them have spilt their guts underneath and one exploded.

      Not Jamicon as stated above but Jackcon caps

      2 x Jackcon 4.7uf 400v that have leaked
      Attached Files

      Comment

      Previous template Next
      Working...
      X