Re: HP 2007W LCD Monitor
The test point you wanted me to measure reads around 5.25V, the regulator reads 5.25V on the one side and 5.25V and 13mV, respectively. The fuse reads 5.25v on the side from the ribbon cable and 0v on the other side.
Do you think that maybe I soldered on a fuse that was too low? Should I try jumping it with a wire? I have some resistors but they're 1/8w - 1/2w. I'd think the 1/8w would maybe be too much. What do you think?
Also, I don't know if this is important or not but the bigger regulator on the corner of the logic board is fairly hot. Hot enough where I can't keep my finger on it for only a couple of seconds.
The test point you wanted me to measure reads around 5.25V, the regulator reads 5.25V on the one side and 5.25V and 13mV, respectively. The fuse reads 5.25v on the side from the ribbon cable and 0v on the other side.
Do you think that maybe I soldered on a fuse that was too low? Should I try jumping it with a wire? I have some resistors but they're 1/8w - 1/2w. I'd think the 1/8w would maybe be too much. What do you think?
Also, I don't know if this is important or not but the bigger regulator on the corner of the logic board is fairly hot. Hot enough where I can't keep my finger on it for only a couple of seconds.
Comment