Hello all,
I have a Hanns G 281D that I purchased about three years ago and now i'm currently having a problem with it. The monitor will not work under its normal resolution (1920x1200) without it being fully warmed up. In order for me to "warm up" the monitor I have to use 800x600 resolution and slowly increase the resolution over time. Once I finally get into 1920x1200 over several hours, I have to put a sweat shirt on the back side of the monitor otherwise the picture will go out. The normal blue LED light that shows when the monitor is on stopped a few months after I purchased the monitor so I am unable to tell if it is flashing. I opened up the back of the case to see if any capacitors were bad but I am unable to see any that are faulty. I'll post some pictures on this tomorrow. Does this sound like a capacitor problem to you guys?
I have a Hanns G 281D that I purchased about three years ago and now i'm currently having a problem with it. The monitor will not work under its normal resolution (1920x1200) without it being fully warmed up. In order for me to "warm up" the monitor I have to use 800x600 resolution and slowly increase the resolution over time. Once I finally get into 1920x1200 over several hours, I have to put a sweat shirt on the back side of the monitor otherwise the picture will go out. The normal blue LED light that shows when the monitor is on stopped a few months after I purchased the monitor so I am unable to tell if it is flashing. I opened up the back of the case to see if any capacitors were bad but I am unable to see any that are faulty. I'll post some pictures on this tomorrow. Does this sound like a capacitor problem to you guys?
Comment