hi everybody
I have done a DIY videoprojector with a base of a packard bell sreen,
I'm using an ATX alimentation of a pc, (+12, +5, GND) and the signals BLON & BRI are tied to the ground.
The image is fine on the screen but there is a big black rectangle in... what could be the source of it?
I can see a cms component that could be a fuse, shoult I shunt it?
(pix are comming)
thank you very much
(I apologize for my english, I'm french )
I have done a DIY videoprojector with a base of a packard bell sreen,
I'm using an ATX alimentation of a pc, (+12, +5, GND) and the signals BLON & BRI are tied to the ground.
The image is fine on the screen but there is a big black rectangle in... what could be the source of it?
I can see a cms component that could be a fuse, shoult I shunt it?
(pix are comming)
thank you very much
(I apologize for my english, I'm french )
Comment