Hello there.
The TV will turn on for about 2 seconds and then go to black. After opening it, I noticed that the connector on the power supply board is burnt, as if too much current was being drawn. I've attached a photo of this.
I took some measurements on the inverter board closest to the power supply (master?), as mentioned in this thread:
https://www.badcaps.net/forum/showthread.php?t=20203
The backlight seems ok when it's on for the 2 seconds, so I didn't check the bulbs.
Does it look like I should just order a replacement master inverter? What else can I measure to narrow down the issue?
thanks.
The TV will turn on for about 2 seconds and then go to black. After opening it, I noticed that the connector on the power supply board is burnt, as if too much current was being drawn. I've attached a photo of this.
I took some measurements on the inverter board closest to the power supply (master?), as mentioned in this thread:
https://www.badcaps.net/forum/showthread.php?t=20203
The backlight seems ok when it's on for the 2 seconds, so I didn't check the bulbs.
Does it look like I should just order a replacement master inverter? What else can I measure to narrow down the issue?
thanks.
Comment